Help Door Handle Will Not Turn Or Op

Removing it and resetting it might help especially if it is a twist adjusted backset type.
Help door handle will not turn or op. Remove the handles including the thru spindle. If the latch itself won t retract extend it is more than likely just bound up. Here are the general steps to remove the handle and lock from the. If the set screw on the handle is stripped and difficult to tighten replace it with a new one.
Usually you take both knobs off then loosen some screws in the edge of the door strike plate and pull it right out. Use a tool a flathead screwdriver will work to twist within the gap the thru spindle inserts into. When this happens the door does not shut and opens up at any time. The knob will not turn to retract the stuck door latch.
The hold open washer sometimes binds causing the door to remain partially open. More force is needed to turn the knob and unstick the latch. Using a thin flat but sturdy item like a credit card or putty knife attempt to access the angled side of the door latch and push it into the door s recess. Try to insert a small screwdriver between the door and the jamb and push the bolt back while turning the mechanism in the door.
Your handle or knob is not properly interacting with the spring and or latch which is causing the spinning without opening. The handle or knob must be jiggled to unstick the latch. It may help to push or pull on the door on the door at the same time. Paint on the edge of the door sometimes prevents the barrel from retracting.
A very common problem that is associated with door knobs is that they do not latch properly. You will need to remove the door handle to begin testing what may be wrong. Use a screwdriver to turn the bolt mechanism the part that actually locks the door. Leave the striker bolt in place.
If none of this helps try to tap the pins out of the hinges. It will come in two pieces. If this is the problem clean the paint off. You can make sure that it is the latch by looking at the strike plate and noticing if the tongue sets in the strike plate correctly.
Once the door is open try to actuate the door latch with the handle. To fix the door knob figure out where the connections have gone awry. Remove the two screws one on either side of the handle and remove the knob. See if this retracts the handle.
Lubricate the inside of the mechanism if the lock still does not function. The problem could be with various connections inside the door handle or lock. Door handle won t latch step 1 check to be sure the closer is pulling the door. The door latch is not extended before rotating the knob.