Going From Tile To Tongue And Groove On Wall

To install tongue and groove paneling vertically begin by nailing 1 by 3 furring strips horizontally either directly to the wall studs on a new wall or over the drywall on a finished wall.
Going from tile to tongue and groove on wall. Hello i would like to do ceramic tile on this bathroom wall someone has made the wall with 3 4 tongue and groove wood. Alternatively another option is to strengthen the substrate with either a layer of floor screed or by overboarding with plywood tile backer board and then using an improved flexible s1 tile adhesive. You can see the imprint of where the old bathroom vanity was. The paneling will be nailed directly to these furring strips.
Fortunately when putting these on as paneling they are a lot easier than the ceiling and this brings installation costs or difficulty level if this is a do it yourself project down. I ve represented tongue and groove with the blue dashes and tiles with the green dots. The traditional method of nailing hardwood tongue and groove flooring is to drive nails at an angle through the tongue of a plank and into the subfloor below but this is time consuming and can. And should we tile up to the ceiling on walls a and b or up to around 6 foot high and have bare wall for the rest just as there would be on walls d e and f but not wall c as those panels go up to the ceiling already.
Nail up the first panel at a corner of the room with the tongue side facing out. The wood was put directly over the 2x4 studs and appears to be pretty solid.